We run into the same thing here when we shift a bunch of cows at once. If one cow walks through a box or a drinker in the new area, Horizon updates her right away, but when you move a whole group they don’t all hit a device immediatelyso they stay stuck on the old location list. What we do now is either push them past a device (robot, selection gate, water trough sensor, whatever picks them up fastest) or wait a bit until they all walk around. But yeah… when you move 5–10 cows at once, Horizon doesn’t always keep up, and they end up on the fetch list for the wrong section. A proper batch location change button would make life a lot easier. Something where you select the group and update all of them in one go instead of clicking through cows one by one. That would save a lot of time and make the fetch lists and TMR numbers more accurate too.

We run into the same thing here when we shift a bunch of cows at once. If one cow walks through a box or a drinker in the new area, Horizon updates her right away, but when you move a whole group they don’t all hit a device immediatelyso they stay stuck on the old location list. What we do now is either push them past a device (robot, selection gate, water trough sensor, whatever picks them up fastest) or wait a bit until they all walk around. But yeah… when you move 5–10 cows at once, Horizon doesn’t always keep up, and they end up on the fetch list for the wrong section. A proper batch location change button would make life a lot easier. Something where you select the group and update all of them in one go instead of clicking through cows one by one. That would save a lot of time and make the fetch lists and TMR numbers more accurate too.